How to Fill and Use Oil Lamps

oil lamp

You may not think there’s much to learn about filling and using an oil lamp, but there are some little tips and tricks to make the job easy. It’s not like flipping a light switch. It isn’t difficult but, done correctly, it will become second nature to you.

When the power goes out due to a storm, disaster, or power company issue, it’s comforting to have several methods of providing light when evening comes.

Candles and flashlights are very useful, but an oil lamp will burn from 60-120 hours, allowing your family to play games or read to take your minds off that TV show you know you’re missing.

Types of Oil

Many people advocate using vegetable oils in oil lamps. If you don’t mind the “off” smell, these types of oil can be used. (Using a few drops of your favorite essential oil will help disguise the smell.) If you have stored a lot of vegetable oil and it goes rancid, it would be better to burn it in your lamp than consume it. Rancid oil can be very detrimental to your health — like poison. However, I must caution you never to use gasoline, alcohol or camping fuel in an oil lamp. They are too volatile and burn dirty. By the way, the so-called “odorless” lamp oils are not completely odorless, but if you had to use your oil lamp for days, you would probably get used to the smell.

When storing lamp oil, be aware that it can actually freeze below 20 degrees. It’s best to have your oil at room temperature before filling the lamp. Cold oil burns a bit faster than oil at room temperature (I have no idea why) — oil will burn about 1/2 ounce per hour. That means a half gallon of oil will last approximately 140-150 hours. (Vegetable oils will last slightly less.)

If lamp oil comes in a plastic container, it’s best to transfer it to a glass or metal container for long term storage. The plastic containers become brittle after a while and can be easily broken or punctured.

Assembling Your Oil Lamp

  1. Remove the glass chimney and unscrew the burner assembly.
  2. Pour in lamp oil. Do not overfill. The lamp oil level should be at least half an inch below the reservoir lip.
  3. Thread the wick into the burner assembly.
  4. Screw the burner assembly back onto the base and allow the wick to become completely saturated with lamp oil.

Lighting Your Oil Lamp

  1. Turn the wick up until it is just high enough over the brass lip to light easily, approximately one-fourth of an inch.
  2. After lighting, turn the wick back down to level with or barely below the brass lip.
  3. Replace the glass chimney on the burner so it fits tightly inside the chimney bracket. You then can adjust the wick slightly up or down to achieve the desired brightness. Generally, the higher the wick, the higher the flame and the brighter the light.
  4. Watch for smoking. The wick should never be extended above the combustion chamber (brass lip) because that will result in incomplete combustion and will cause smoke and soot deposits, as well as excessive heat. If you see smoke or soot, lower the wick until it stops.
  5. To turn off the lamp, turn the wick down into the burner until the flame goes out. Don’t turn it so far as to unthread the wick from the burner assembly completely.

Moving a HOT Lamp

After an oil lamp has been burning for any substantial length of time, the chimney will be extremely hot. If you absolutely must move the lamp, do so by the handle only — carefully. Better yet, set the lamp where you want it in the first place and don’t move the lamp once you’ve lighted it.

After turning it off for the night, let it sit for a few minutes to cool slightly and then you can move it to a secure out-of-the-way spot until it’s needed again.

Do not put the hot lamp or chimney on a cold tile counter—it could crack the lamp or the tile. Set the hot lamp on a pot holder or folded towel to cool.

Article Source: http://www.family-survival-planning.com/oil-lamps.html

Leave a Reply

Your email address will not be published. Required fields are marked *